Nov 28, 2024
Manual Dosing for Crystalline Experiments
This protocol is a draft, published without a DOI.
- Connor Clark1
- 1CMAC
Protocol Citation: Connor Clark 2024. Manual Dosing for Crystalline Experiments. protocols.io https://protocols.io/view/manual-dosing-for-crystalline-experiments-ddgu23ww
License: This is an open access protocol distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited
Protocol status: Working
We use this protocol and it's working
Created: May 10, 2024
Last Modified: November 28, 2024
Protocol Integer ID: 99572
Keywords: manual dosing for crystalline experiments manual, crystalline experiments manual, manual dosing, dosing procedure, procedure for solute, solvent, solute, screening, experiment
Abstract
Manual dosing procedure for solutes and solvents in the Crystallisation Screening DataFactory
Troubleshooting
Solute Weighing
If balance is unused that week so far, carry out weight check, results to be added to spreadsheet
\\ds.strath.ac.uk\idrive\Science\SIPBS\cmac\CCS DataFactory\Balance calibration.xlsx
Check spirit level to ensure the balance is levelled
Zero the balance
Weigh empty vial
If material is known to be static, weigh vial with cap screwed on, otherwise weigh the vial uncapped
Tare balance
Remove vial from balance and add material via spatula
reweigh vial
(with or without cap dependent on actions from step 4.1
Review mass, and determine if the mass satisfies requirements (<1% from target mass)
If yes, can proceed.
If mass is under target weight by >1%, repeat step 6 onwards until satisfactory
If mass is over target weight by >1%, remove and dispose of sample in waste, repeat step 8 onwards until satisfactory
Solvent Weighing
If following from previous steps, tare balance with vial and solute.
Remove vial from balance and add solvent via pipette
Review mass, and determine if the mass satisfies requirements (<1% from target mass)
If yes, can proceed.
If mass is under target weight by >1%, repeat step 6 onwards until satisfactory
If mass is over target weight by >1%, consider recalculation of concentration and whether it is acceptable
If required, tare balance and add solute to reach the required concentration (i.e. follow steps 6 through 8 and optionally 9 through 11, until concentration is satisfactory
If target mass and concentration has been met, record masses and concentrations
Continue onto crystalline experiments