Jun 28, 2024
In vitro digestion method for Atlantic salmon
- Gopika Radhakrishnan1,2,
- marta Silva1,
- Ikram Belghit1
- 1Institute of Marine Research;
- 2University of Bergen
Protocol Citation: Gopika Radhakrishnan, marta Silva, Ikram Belghit 2024. In vitro digestion method for Atlantic salmon . protocols.io https://dx.doi.org/10.17504/protocols.io.5jyl8j3b7g2w/v1
License: This is an open access protocol distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited
Protocol status: In development
We are still developing and optimizing this protocol
Created: May 30, 2023
Last Modified: June 28, 2024
Protocol Integer ID: 82628
Keywords: availability, feed ingredient, insect meal, in vitro, digestion method for atlantic salmon, experimental diets for atlantic salmon, types of insect meal, insect meal, digestion method, defatted bsfl meal, amino acid solubility of different black soldier, experimental diet, larvae, atlantic salmon, digestion, amino acid solubility, microwave full fat bsfl, meal, different processing technique
Funders Acknowledgements:
European Union’s Horizon 2020, SUSINCHAIN
Grant ID: 861976
Abstract
This in vitro digestion method was used to evaluate amino acid solubility of different black soldier fly larvae (BSFL) meals and experimental diets for Atlantic salmon. Three types of insect meal that had been through different processing techniques included: a microwave full fat BSFL (BSFM), defatted BSFL meal with an enzymatic pre-treatment (BSFE) and a defatted BSFL meal without enzymatic pre-treatment (BSFH).
Troubleshooting
Extraction of crude salmon enzymes
Due to biological variability, use the viscera from at least 6 fish. The exact number of fish required will depend on the quantity of enzyme needed for the experiment.
Feed the fish 40 g of feed 4 hours before collecting tissues (e.g. commercial feed (Supreme Plus15, Skretting, crude protein 51%)).
After 4 h, the fish were anaethetised (e.g. imersing the fish in water containing 100 mg/L of MS222). This step was followed by a quick cephalic concussion.
Dissect the fish by separating stomach and pyloric ceca + intestine.
Dissected Atlantic salmon.
Gastrointestinal tract of Atlantic salmon.
Note the pH of the stomach and intestines before the excision.
Note: All the steps from 4 to 6 should be performed at low temperature, by possible keeping on ice.
Wash the stomach and the intestine along with pyloric caeca with cold milliQ water.
Note: This step is meant to remove blood stains and fat.
Chop the tissues into smaller pieces and homogenise with cold (4°C) milliQ water in 1:10 ratio using a tissue homogeniser (Polytron PT 2100).
Homogenization of tissues.
Note: To prevent overheating, the homogenization was conducted in several 30-second pulses. Throughout this process, the homogenate was kept in a glass beaker on ice to preserve the integrity of the tissue's proteins and enzymes.
Centrifuge the homogenised samples at 3220× g for 30 min at 4°C (Fisher Scientific, Eppendorf 5810R Centrifuges with A-4-81 Model Rotor).
Example of how the samples were submitted to centrifuge.
Collected supernatant which constituted the crude enzyme extract were stored at -80°C until further use. Discard pellet (these are mostly tissue debris).
Dialysis
Prior to measuring enzyme activity or conducting in vitro experiments, the crude enzyme extracts were further concentrated through dialysis using 10 MWCO dialysis tubes.
Determination of pepsin and protease activity
The assay was initiated by adding 5 mL of the substrate into the glass tubes named blank and test. All the tubes were placed at 37°C for approximately 10 min to equilibrate.
This was followed by addition of 1 mL of enzyme solution into the test tubes and were placed at 37°C for 10 min to incubate.
Subsequently, the reaction was stopped by adding 10 mL of 5% trichloroacetic acid (TCA) to each tube. For the blank tube, 1 mL of the enzyme solution was added after the TCA. All tubes were thoroughly mixed and then maintained at 37°C for 5 minutes.
Equipment and solutions used for the protocol.
All tubes (blank and test tubes) were centrifuged at 3200×g for 10 min at 4°C, and absorbances of the supernatant were read at 280 nm (UV-VIS Spectrophotometer, Shimadzu, Model: UV-1800, USA).
Determination of enzyme activity.
One unit of pepsin activity was defined as the change in absorbance of 0.001 per min. at pH 2 at 37°C measured as TCA soluble products. All measurements were conducted in duplicate.
Determination of protease activity
In this assay, the protease activity of the stock solution was measured using casein as the standard substrate.
To begin with, 20 µL of enzyme solution was mixed with 0.5 mL of 0.1M Tris-HCl buffer (pH 8) at room temperature.
The reaction was initiated by the addition of 0.5 mL of 1% casein and kept for 30 min.
Afterwards, the reaction was terminated by adding 0.5 mL of 20% TCA. The mixtures were then left to stand for 10 minutes at room temperature, followed by centrifugation at 16500×g for 5 minutes at 4°C.
The absorbance of the reaction mixture was read at 280 nm using a UV-VIS Spectrophotometer (Shimadzu, Model: UV-1800). Enzyme activity was defined as the release of 1 µg of tyrosine per minute, as per Walter (1984). All measurements were conducted in duplicate.
In vitro digestion of feed ingredients and diets
The in vitro digestion method included two steps: acidic and alkaline hydrolysis which is meant to correspond to the conditions in the stomach and the intestine, respectively.
An appropriate amount of sample, equivalent to approximately 80 mg of protein, was weighted in a round bottom tube (13 mL).
An acidic (0.01N HCl, pH 2) and an alkaline solution (0.01N NaOH, pH 8) were prepared by diluting HCl and a weighted amount of NaOH in Milli-Q water.
Initially, the samples were incubated with 200 µL of gastric enzyme extract and 4.8 mL of acidic solution to a volume of 5 mL. The mixture was allowed to stand for 1 h at room temperature under continuous rotation (20 rpm).
Example of continuous rotation.
After 1 h, a set of samples were stopped after the first step of digestion (gastric simulation, acidic hydrolysis) and kept for further analysis, while another set of samples were processed for the second step of digestion (gastrointestinal simulation, acid hydrolysis followed by alkaline hydrolysis).
The second step of digestion was started by incubating the samples with the 3.3 mL of intestinal crude enzyme and alkaline solution to make up to a volume of 10 mL. This mixture was again allowed to stand for 1 h at room temperature under continuous rotation (20 rpm) by keeping the ratio of 5U of pepsin or protease per mg of protein.
After removing the samples from the rotator, they were submitted to centrifugation (3000 g, 10 min) and the soluble fractions were transferred to new tubes. All tubes were immediately placed on ice to stop the enzyme activity.
Note: In this experiment, a set of tubes without sample was included (blanks). The purpose of these tubes is to evaluate background inputs from enzymes and working solutions. All samples should be studied at least in duplicates.
For the ingredients and diets, the soluble fractions and non-soluble samples were collected from the gastric simulation phase (acid hydrolysis, GS) and from the gastrointestinal simulation phases (acid hydrolysis followed by alkaline hydrolysis, GIS). Samples were stored at -20°C before analysis.
Protocol references
The extraction of crude salmon gut enzyme method was developed based on principles described elsewhere (Alarcón et al., 2002, Rahmah et al., 2016, Yasumaru and Lemos, 2014, Radhakrishnan et al., 2022).
Total pepsin activity of crude extract was assayed according to the method described by Anson and Mirsky (1932).
The total protease activity of crude extract was measured according to Walter (1984).